Acute and short-term mechanical response to different set configurations in the bench press exercise
Author:
Páez-Maldonado, José Antonio; Jiménez-Roldán, Manuel Jesús; Galiano, Carlos; Pareja-Blanco, FernandoISBN:
978 -84 -1351-478 -9Date:
2026-07-13Abstract:
Velocity loss (VL) is defined as the reduction in repetition velocity within a set and can predict the level of effort exerted against a given relative load. Interestingly, a strong relationship (R2 = 0.97) has been observed between VL during the set and the percentage of repetitions completed with respect to the maximum number of repetitions (MNR) in the bench press (BP) exercise. A 50% VL is close to failure, whereas 25% VL corresponds to approximately 50% of the MNR in BP (Rodriguez-Rosell et al., 2020). Pareja-Blanco et al. (2020) showed that fatigue and the time needed for recovery increase with proximity to failure. In addition, cluster sets (CS) are an effective method for reducing the decrease in velocity during resistance training by adding short rests within sets (Tufano et al., 2017). To our knowledge, no study has analyzed the time course of recovery to resistance protocols with the same VL induced in the set but with different set configurations. Therefore, this study aimed to analyze the acute and short-term mechanical response to four BP protocols that differed in set configuration (CS vs. traditional set) and two different VL thresholds (25% vs 50%).
Velocity loss (VL) is defined as the reduction in repetition velocity within a set and can predict the level of effort exerted against a given relative load. Interestingly, a strong relationship (R2 = 0.97) has been observed between VL during the set and the percentage of repetitions completed with respect to the maximum number of repetitions (MNR) in the bench press (BP) exercise. A 50% VL is close to failure, whereas 25% VL corresponds to approximately 50% of the MNR in BP (Rodriguez-Rosell et al., 2020). Pareja-Blanco et al. (2020) showed that fatigue and the time needed for recovery increase with proximity to failure. In addition, cluster sets (CS) are an effective method for reducing the decrease in velocity during resistance training by adding short rests within sets (Tufano et al., 2017). To our knowledge, no study has analyzed the time course of recovery to resistance protocols with the same VL induced in the set but with different set configurations. Therefore, this study aimed to analyze the acute and short-term mechanical response to four BP protocols that differed in set configuration (CS vs. traditional set) and two different VL thresholds (25% vs 50%).
Collections
Files in this item



